Updating old electrical outlets Wibe camesex


19-Jul-2017 22:41

You will have to drill a new hole for the new cable.

If you are refeeding an outlet or a light switch and you can't reuse the old cable's hole, a new hole is necessary.

Besides replacing the wiring, you should also consider replacing your electrical service, which includes your main panel and any subpanels.

Also note that it may be against the law, code, or regulations to do this without a permit, or it might void your insurance or warranty. RELATED: If you like the idea of streamlining your USB charging but you can’t perform the upgrade yourself, don’t want to pay an electrician to do it, or you’re a renter or apartment dweller who can’t change the wiring of your home, you should definitely check out our guide to USB charging stations–it’s all the USB charging goodness without any risk of electrocution.

It may be possible to pull the old cable back through the hole in which it runs.

However, if it is stapled in place, then that is not an option.

This kind of remodeling is easier to do in a newly purchased home than a well lived-in one.

Do not attempt to replace your own wiring unless you are experienced in electrical construction.If you want to clean things up, you can upgrade your outlets to support not just standard 120-volt power cords but 5v USB charging too. There’s no shame in getting someone else to do the actual wiring for you if you lack the skill or knowledge to do so.If you read the beginning of this article and immediately visualized to do it based on past experience wiring switches and outlets, you’re probably good.Also, it may be advisable if your old panel is in bad condition or if you have fuses instead of circuit breakers. He lives in Oakland, Calif., working as an electrician and carpenter. Clair holds a bachelor's degree in public policy from Emory & Henry College and a master's degree in city planning from University of North Carolina-Chapel Hill, where he specialized in food system planning.



Rewiring involves removing as much of the old wire as possible and installing modern, so-called non-metallic wire. Compared to older wiring types, non-metallic is.… continue reading »


Read more